Skip to lesson content

Lesson 9 of 13

Ray Optics and Optical Instruments · Lesson 9 of 13

Prisms, Minimum Deviation and Dispersion

“Derive prism geometry, interpret the deviation curve and explain colour-dependent refraction.”

Learning Objectives

• Derive the angle-sum and deviation relations for a prism. • Determine index from minimum deviation. • Use the thin-prism approximation with its limits. • Explain dispersion and test whether a ray exits or is internally reflected.

Two nonparallel faces leave a net deviation

A parallel slab returns the ray to its original direction, but a prism has nonparallel refracting faces. Let the angle between the two faces be A. At the first face define incidence i and internal refraction r₁; at the second define internal incidence r₂ and emergence e. Every angle is measured from the appropriate face normal. Let δ be the angle between the original propagation direction and the outgoing direction. The surrounding medium is assumed identical at both faces.

Minimum deviation in an equilateral prismA = 60°n = 1.50i = e = 48.59°r₁ = r₂ = 30°Refraction angles are 30° from the local normals, not from the faces.
Symmetric passage through a triangular prism— This equilateral prism example uses n = 1.50 in air; the internal ray is horizontal at minimum deviation.

The two surface normals are each perpendicular to their face. In the quadrilateral containing the prism apex and the two incidence points, the remaining internal angle is 180° − A. In the triangle made by those normals and the internal ray, r₁ + r₂ plus that angle is 180°. Subtract the two angle sums to obtain r₁ + r₂ = A. The first face changes the ray direction by i − r₁ and the second by e − r₂. Adding these directional turns gives δ = i + e − A. These geometric relations must be combined with Snell’s law; they alone do not determine the path.

Prism geometry and refractionLaTeX
n_rel = n_prism/n_outside. Relations assume a transmitted path crossing the two stated faces.

The minimum-deviation condition

Rotate a prism in a fixed monochromatic beam and measure the deviation. It first decreases and then increases within the transmitted range, producing a minimum δ_min. Reversibility means that interchanging incidence and emergence traces the same path in reverse and gives the same deviation. At the symmetric minimum, i = e. Snell’s law then gives r₁ = r₂, and their sum gives r₁ = r₂ = A/2. Since δ_min = 2i − A, i = (A + δ_min)/2. Substituting into Snell’s law gives the index formula. For an isosceles prism in this symmetric arrangement the internal ray is parallel to its base; this statement need not hold for an arbitrarily shaped prism base.

Index from minimum deviationLaTeX
n_p and n_m are prism and surrounding-medium indices at the selected light frequency. A and δ_min must use consistent angle units.
Prism deviation curve from Snell’s lawincidence i (degrees)deviation δ (degrees)30405060708030405060δ_min = 37.18°A = 60°, n_rel = 1.50. Only transmitted paths are plotted.
Deviation as incidence changes— Curve points are calculated using full Snell geometry for a 60° prism with relative index 1.50.
The surrounding liquid matters

Problem
A prism has A = 60° and minimum deviation 40° in air. Find its glass index and its minimum deviation in water of index 1.33.

  1. 1.In air, n_p = sin 50°/sin 30° = 1.5321.
  2. 2.In water the relative index is 1.5321/1.33 = 1.15195. At the symmetric path i = arcsin(1.15195 sin 30°) = 35.1678°.
  3. 3.Thus δ_min = 2i − 60° = 10.34°. The prism bends less because the index contrast is smaller.

Thin-prism approximation

For small A with small refraction and incidence angles, replace each sine by its angle in radians. Then i ≈ n_rel r₁ and e ≈ n_rel r₂. Add them and use r₁ + r₂ = A: i + e ≈ n_rel A. Therefore δ ≈ (n_rel − 1)A. This also follows at the minimum from the exact formula. A small apex angle alone does not justify the approximation for an arbitrarily near-grazing path. Treat the ray angles as small too.

Small-angle prism deviationLaTeX
A and δ are angles in the same unit; the sine approximations are justified in radians. Use only the small-angle transmitted regime.

Dispersion: a material changes different colours differently

The refractive index depends on frequency. In ordinary transparent glass in its normal-dispersion visible range, violet light has a larger index than red light. A prism therefore gives violet a greater deviation toward the base than red. White light separates into a spread of colours; a monochromatic incident beam only changes direction. The prism does not manufacture the constituent frequencies. Frequency is retained at stationary interfaces even though different colours have different speeds and wavelengths inside the prism.

The same dependence gives a lens different focal lengths for different colours: chromatic aberration. It can occur in thin as well as thick lenses. Reflecting surfaces avoid this particular refractive-index focus spread, although a real mirror system can have other aberrations. An object’s perceived colour also depends on illumination: a red surface under narrowband blue light may appear dark if it reflects little blue. Ray optics predicts paths, while a full account of colour perception additionally needs spectral response of materials and the eye.

A prism ray may fail to emerge

At the second face light goes from prism to a lower-index surrounding medium. First compute r₁ from the entrance law, then r₂ = A − r₁. If r₂ exceeds the critical angle, there is no transmitted emerging ray from that face. At equality the limiting emerging ray grazes the face. For A = 60° and n = 1.524 in air, i_c = arcsin(1/1.524) ≈ 41.01°. The threshold entrance angle obeys sin i = n sin(A − i_c), giving about 29.73°. Within this path geometry, smaller entrance incidence gives larger r₂ and total reflection; the equality is the threshold, not already a strictly supercritical ray.

A minimum-deviation measurement should use a narrow monochromatic beam, a measured apex angle and several incidence settings spanning the minimum. Equal deviations on two sides of the minimum correspond to reversed paths, not two different material indices. The graph must be restricted to angles for which transmission through both faces is possible.

Quick Quiz

Quiz

Quick check

For a prism, the internal angles satisfy

Explanation: This follows from the two face normals and the apex-angle geometry.

Quick check

At minimum deviation in the ordinary symmetric transmitted path

Explanation: The path is symmetric under reversal.

Quick check

The index in the prism minimum-deviation formula is

Explanation: Immersion changes the relative refractive index.

Quick check

In ordinary visible normal dispersion, a glass prism deviates

Explanation: Violet usually has the greater glass refractive index.

Quick check

If second-face internal incidence exceeds its critical angle, the ray

Explanation: At equality emergence grazes; above it no propagating refracted ray exists.

Practice Problems

Practice Problems
  1. A prism has A = 60° and n = 1.50 in air. Find its minimum deviation.
  2. Find the deviation of a 4° thin prism of index 1.50 in air in the small-angle regime.
  3. A 60° prism has δ_min = 40° in air. Find its relative index in n = 1.33 water and new δ_min.
  4. For A = 60° and n = 1.524 in air, find the threshold entrance incidence for grazing emergence at the second face.
  5. Explain why white light spreads through a prism but not because its frequency changes at each surface.

At minimum, r = 30° and sin i = 1.50 sin 30° = 0.75. Thus i = 48.590° and δ_min = 2i − 60° = 37.181°. The result is not (n − 1)A = 30°, since this is not a thin small-angle prism.

Key Takeaways

Key Takeaways

• Prism internal angles obey r₁ + r₂ = A. • The net deviation is i + e − A. • At minimum deviation the transmitted path has i = e and r₁ = r₂ = A/2. • The index formula uses prism index relative to the surrounding medium. • Thin-prism deviation is approximately (n_rel − 1)A in the small-angle regime. • Dispersion separates existing frequency components by different refractive paths. • Check the critical angle before assuming a second-face emerging ray.

Finished this lesson? Mark it complete to track your progress.

Loading your progress…