Skip to lesson content

Lesson 5 of 13

Ray Optics and Optical Instruments · Lesson 5 of 13

Imaging at a Spherical Refracting Surface

“Derive the single-interface imaging relation and use its limiting cases to understand curved refraction.”

Learning Objectives

• Derive the paraxial spherical-interface equation from Snell’s law. • Assign signed u, v and R at a refracting surface. • Interpret real and virtual interface images. • Check plane-boundary and index-matching limits.

Why a curved boundary can focus

A flat water surface changes the apparent depth of a submerged point. A curved transparent boundary can also bring initially diverging rays to a real image because its local normal changes from point to point. A glass sphere, a curved aquarium wall and each face of a lens all use this principle. Start with just one spherical boundary. Let medium 1 contain the incoming light and medium 2 the outgoing light. The vertex P is the origin, the principal axis points with the incoming axial light, and the centre C has signed coordinate R. Unlike a mirror, the transmitted ray continues into medium 2.

For the derivation take a real axial object O to the left, a convex boundary with C to the right, and an image I to the right. Use positive geometric magnitudes U = PO, V = PI and R = PC, and a paraxial point N at height y. Replace its axial projection by P to first order; the surface sag is second order in height. The ray ON makes small angle α ≈ y/U with the axis, the normal NC makes angle γ ≈ y/R, and NI makes small angle β ≈ y/V. These are angle magnitudes; the incident and refracted slopes have different signs.

One spherical refracting surfaceprincipal axisOPCIn₁ = 1.00n₂ = 1.50Nnormal through CParaxial geometry: U = 40, R = 10, V = 60 in common length units.
Refraction at one convex spherical interface— Object and image are on the axis. The surface normal joins N to C; ray slopes use the paraxial approximation.

Build the equation one angle at a time

At N, the normal slopes down toward C. The incoming ray slopes up, so incidence i = α + γ. The outgoing ray slopes down toward I but less steeply than the normal in this construction, so r = γ − β. Small-angle Snell’s law gives n₁(α + γ) = n₂(γ − β). Move the β term to the left and the n₁γ term to the right: n₁α + n₂β = (n₂ − n₁)γ. Substituting the height ratios and cancelling y gives n₁/U + n₂/V = (n₂ − n₁)/R. Finally apply u = −U and v = +V. Keeping the signed form allows the other paraxial configurations to be handled consistently.

Spherical-interface imagingLaTeX
Indices are dimensionless; u, v and R must use one length unit. This is a first-order paraxial equation for one spherical boundary, not a whole thick lens.

The left side combines outgoing and incoming ray geometry; the right side expresses refracting strength from index contrast and curvature. A centre on the positive side gives R > 0 even if the surface looks concave from another viewpoint. Describe which side contains the incoming light rather than deciding the sign from a drawing alone. For transmission into medium 2, v > 0 means actual outgoing convergence on that side; v < 0 means a virtual image inferred from backward extensions.

A curved glass block

Problem
A point is 100 cm in front of a convex air–glass interface with R = +20 cm and glass index 1.50. Locate its image.

  1. 1.Use n₁ = 1, n₂ = 1.50 and u = −100 cm. Then 1.50/v + 1/100 = 0.50/20 = 0.025 cm⁻¹.
  2. 2.Thus 1.50/v = 0.015 cm⁻¹ and v = +100 cm. The transmitted rays converge inside the glass, provided the block extends to that position.
  3. 3.The result differs from a thin lens: one interface does not obey 1/v − 1/u = 1/f with equal indices on both sides.

Useful checks and focal distances

If R tends to infinity, the boundary becomes plane and its right side vanishes. Then v = (n₂/n₁)u. For an object in water and outgoing rays in air, v is negative and its magnitude is the near-normal apparent depth. If n₂ = n₁ there is no optical boundary; v = u. The outgoing rays retain their original divergence, so this equality describes their unchanged apparent origin rather than a newly produced image. For an object at infinity, 1/u = 0 and the image-side focal coordinate is v_f = n₂R/(n₂ − n₁). The object-side point producing parallel output follows from 1/v = 0: u_f = −n₁R/(n₂ − n₁). Their magnitudes generally differ because the two media differ.

Two focal coordinates of one interfaceLaTeX
These are coordinates from the surface vertex. Do not assume equal focal distances when the media have unequal indices.

What the paraxial model leaves out

Real curved surfaces have a finite aperture. Large-angle Snell tracing can show spherical aberration, so rays at very different heights need not meet at the single point predicted by the first-order formula. Wavelength dependence of index can also move the focus for different colours. These limitations explain why high-quality optical systems use carefully shaped or multiple components. The next step is to apply the single-interface equation twice to a thin lens, where an intermediate image is a mathematical tool even when the rays encounter the second surface before reaching it.

Quick Quiz

Quiz

Quick check

For an air-to-glass convex boundary with centre to the right and light from left, R is

Explanation: R is the centre coordinate measured with the incoming axial direction.

Quick check

A single refracting interface is governed by

Explanation: Snell’s law and paraxial geometry yield the index-weighted equation.

Quick check

In the plane-interface limit, the curvature term becomes

Explanation: 1/R tends to zero as R tends to infinity.

Quick check

A transmitted real image on the outgoing side has

Explanation: Its rays actually meet in the positive outgoing region.

Quick check

For n₁ ≠ n₂, the two focal-distance magnitudes of one interface are

Explanation: They carry different factors n₁ and n₂.

Practice Problems

Practice Problems
  1. A real object in air lies 60 cm before a convex glass interface, n₂ = 1.50, R = +20 cm. Find v.
  2. Find the two focal coordinates for n₁ = 1, n₂ = 1.50 and R = +20 cm.
  3. Recover the apparent depth of a point 12 cm below water of n = 1.33 when observed from air.
  4. What does the spherical-interface equation predict if both indices are 1.50?
  5. Explain why a single-interface image at 180 cm may not be observed inside a small glass sphere.

1.50/v − 1/(−60) = 0.50/20. Hence 1.50/v = 0.025 − 0.016667 = 0.008333 cm⁻¹ and v = +180 cm. It is a real paraxial image in glass if no later boundary intervenes.

Key Takeaways

Key Takeaways

• Curved interfaces focus because their local normals vary with position. • The spherical-interface equation follows from small-angle Snell’s law. • Use n₂/v − n₁/u = (n₂ − n₁)/R for a single boundary. • The sign of R follows the centre position relative to the incoming axis. • Unequal media give unequal object-side and image-side focal distances. • A plane boundary recovers the near-normal apparent-depth relation. • A second surface can alter the image predicted for the first surface.

Finished this lesson? Mark it complete to track your progress.

Loading your progress…