Skip to lesson content

Lesson 5 of 11

Electric Charges and Fields · Lesson 5 of 11

Reading Electric Field Lines

“Interpret field-line direction and density without treating the drawing as a literal collection of physical threads.”

Learning Objectives

• Infer electric-field direction from a tangent and compare relative strengths from line density. • Explain why electrostatic field lines do not cross or form closed loops. • Relate inverse-square spreading to three-dimensional area and solid angle. • Distinguish field lines from particle trajectories and from literal flux counts.

From many vectors to a continuous picture

A vector-field map places a small arrow at many sample points. Each arrow gives the direction and magnitude of E at its tail. A field line is a different construction: its tangent at each point follows the local field direction, and an arrow distinguishes the two senses along the tangent. Its length does not represent field strength. It connects directional information through space rather than tracking a particular particle through time. The same map could be drawn with more or fewer lines; the field itself would be unchanged.

Positive sourceNegative source+−
Radial field lines for opposite single-charge signs— The lines represent a section through a three-dimensional field. Arrows point away from + and toward −; their number is chosen for the drawing.

What a line diagram can tell you

Opposite charges+−
Opposite-charge field lines— Numerically traced from the Coulomb vector field. Lines start on + and approach − or extend beyond the displayed region.

For an isolated positive point charge, every line points radially outward; for an isolated negative charge it points inward. Uniform field lines are parallel, equally spaced and point in one direction. For two positive charges, nearby lines bend away from the space between them and no line connects one positive charge to the other. At the midpoint of two equal positive charges the net field is zero, so there is no defined field direction there. For equal-and-opposite charges, many lines run from the positive to the negative source. Between the charges their fields reinforce, even though the total charge of the pair is zero.

FeatureInterpretationLimitation
Arrow tangentDirection of E and force on a positive test chargeForce on a negative charge reverses
Greater line densityLarger |E| under a consistent drawing conventionCount through perpendicular area in three dimensions
No line drawn in a small regionMay just reflect a sparse sketchDoes not prove E = 0
Straight parallel equally spaced linesUniform vector field in the depicted regionReal finite sources may have edge effects

Why the field-line rules hold

Equal positive charges++
Equal-positive-charge field lines— Numerically traced source field. Lines do not join the two positive charges; the midpoint is a zero-field point.

In a charge-free smooth region, a nonzero electrostatic field has a unique direction at each point. Two distinct lines cannot cross there because a crossing would assign two directions to one vector. At a zero-field point the direction is undefined; it is not an exception that permits two nonzero field vectors. Lines can begin on positive charges and end on negative charges, or extend to infinity. They do not abruptly stop at an ordinary charge-free point. Ideal point-source locations are singular, not regular field points.

Electrostatic field lines do not form closed loops. An electrostatic field is conservative: a positive test charge taken around a closed path has zero net electric work. If a nonzero field line formed a closed loop, travelling with its arrow would give positive E·dl all along the loop and hence nonzero work per charge, contradicting that property. This applies specifically to electrostatics; induced electric fields in time-dependent situations need not satisfy the same rule.

Density in three dimensions explains the inverse-square picture

Draw a fixed collection of radial lines from a point source. Every sphere centred on it is pierced by the same collection. A sphere has area 4πr², so spreading those lines over a sphere twice as large in radius makes the line density per unit area four times smaller. This is consistent with the Coulomb field E = k|Q|/r². Counting spacing along a circle in a flat page would instead suggest the wrong dimensional relationship: a page is only a slice of the full spatial field.

Solid angle of a small perpendicular patchLaTeX
A solid angle measures a cone of directions. ΔA⊥ is the area normal to the radial direction; the full sphere subtends 4π steradians. Solid angle is dimensionless, with named unit sr.

The same narrow cone cuts patches proportional to r² on successive spheres. The number of chosen lines within that cone stays fixed, so their density falls as 1/r². This geometric picture supports interpretation of an already established law; a freely chosen line drawing is not an independent measurement of a force. For tilted patches use the projected area normal to E, an idea that leads to electric flux.

Compare line density at two radii

Problem
A radial point-charge field has magnitude 800 N C⁻¹ at r. Predict it at 2r and compare areas cut by the same narrow cone.

  1. 1.The outer patch has four times the area. The same chosen lines cross it, so line density is one quarter.
  2. 2.Coulomb’s field gives E(2r) = E(r)/4 = 200 N C⁻¹, consistent with that density ratio. The total number of drawn radial lines crossing either full sphere stays the same.

A line is not a particle track

A field-line tangent specifies acceleration direction for a positive particle only when electric force dominates; it does not specify velocity. A particle entering a uniform vertical field with horizontal speed follows a parabola while the field lines remain vertical straight lines. A negative particle accelerates opposite their arrows. The common intuition that a particle must slide along a field line confuses a spatial direction map with a history of motion.

Diagnose an impossible sketch

Problem
A diagram shows a closed circular electrostatic field line in a charge-free region. What is wrong?

  1. 1.Following the arrow around the circle makes E·dl positive everywhere if E is nonzero. The resulting closed-loop electric work would be positive.
  2. 2.An electrostatic field must give zero work around a closed loop. Therefore the sketch cannot represent a nonzero electrostatic field; labelling it an electron orbit does not fix the field-line error.
Predict and resolve

If a second author doubles the number of lines everywhere, has the field doubled? No. Only the drawing convention changed. Relative line densities can compare strengths when the convention is kept consistent; an arbitrary count alone has no unit of N C⁻¹.

Quick Quiz

Quiz

Quick check

The tangent to a field line gives

Explanation: The line is a direction map of E, not a universal trajectory.

Quick check

Two distinct lines cross at a regular point with nonzero E. The drawing is

Explanation: A nonzero field has a unique direction at each regular point.

Quick check

Doubling a sphere’s radius around a point charge changes its area by

Explanation: Sphere area is 4πr².

Quick check

A horizontal-moving electron enters a vertical uniform field. Its path generally

Explanation: Horizontal constant velocity combines with constant vertical acceleration.

Quick check

In an electrostatic field, a nonzero closed field-line loop would contradict

Explanation: The work per charge along the loop would have one sign instead of zero.

Practice Problems

Practice Problems
  1. Explain why attraction to a charged comb does not prove that paper had an opposite net charge initially.
  2. A point-charge field is 450 N C⁻¹ at 0.20 m. Predict it at 0.60 m and interpret line density.
  3. Explain why the midpoint field of equal positive charges differs from that of equal opposite charges.
  4. Describe a correct field-line sketch for a single negative point charge and explain its three-dimensional meaning.
  5. Can a blank region of a field-line sketch establish that the field is zero there? How could you decide?

Initially neutral paper contains both signs. The comb’s field can shift their centres slightly, producing polarisation. In its nonuniform field, the nearer opposite charge experiences a stronger attraction than the farther like charge experiences repulsion. A net attractive force is possible with zero paper net charge.

Key Takeaways

Key Takeaways

• Field lines follow the local direction of E. • Their arrows give positive-test-charge force direction. • Relative density represents strength only with a consistent convention. • Three-dimensional perpendicular area controls density comparisons. • Electrostatic lines do not cross at regular nonzero-field points or form closed loops. • Field lines are not physical threads or general particle trajectories.

Finished this lesson? Mark it complete to track your progress.

Loading your progress…