Atoms · Lesson 5 of 7
Photons and Hydrogen Spectra
“Connect emission and absorption lines with atomic energy differences, calculate photon frequencies and wavelengths, and analyse direct and cascade transitions.”
• Distinguish line emission, line absorption and a continuous spectrum. • Use positive energy differences to calculate photon frequency and wavelength. • Trace direct and cascade transitions on a hydrogen energy diagram. • Explain why photon frequency differs from the electron revolution frequency.
Why does a dilute gas produce sharp lines?
A spectrometer separates light by wavelength. An electrically excited dilute atomic gas produces bright narrow lines against a dark background. The pattern is characteristic of the atom and can be used to identify it, even from a distance. Radiation from hot dense matter is often much more continuous because interactions and other processes contribute. A continuous spectrum and a line spectrum therefore offer different clues about the emitting system.
The nuclear picture alone does not select wavelengths. Quantised energy levels provide the missing link: the atom can lose energy only by changing from one available state to another. Each radiative transition transfers a definite energy to a photon. A line belongs to a difference between two levels, not to the absolute energy of one level and not to the radius of one orbit.
The negative signs of bound energies can make subtraction seem awkward. Write the initial and final values first. For 3 → 2, Ei = −1.511 eV and Ef = −3.400 eV, so Ei − Ef = +1.889 eV. A negative photon frequency would signal a mistaken order of subtraction, not a physical negative-energy photon. The reverse absorption needs the same positive photon energy when the lower state is populated.
Absorption depends on which states contain atoms
Place a cooler dilute gas in front of a source with a continuous spectrum. Some photons match transitions from populated lower states to higher ones. Those wavelengths can be removed from the transmitted beam, leaving dark absorption lines. Re-emission can send light in other directions. Absorption is not a dark material line painted onto the source; it is a deficit at particular wavelengths in the line of sight.
Corresponding upward and downward transitions have matching energies. But an emission spectrum and an absorption spectrum need not show every line with the same strength, or even every possible line. State populations and allowed transitions matter. Most cold atomic hydrogen is in n = 1, so its strong ground-state absorption is in the ultraviolet. Visible Balmer absorption requires a significant n = 2 population. An excited emission gas can populate upper states and display visible transitions to n = 2.
From an energy gap to frequency and wavelength
For a photon in vacuum, energy equals hν and wavelength obeys c = νλ. Combining these relationships gives λ = hc/ΔE. The input is always the positive gap. If ΔE is in eV, either convert it to joules before using h in J s, or use the compatible shortcut hc ≈ 1240 eV nm. Mixing eV with SI h without conversion gives an enormous unit error.
Problem
Two atomic levels differ by 2.3 eV. Calculate the frequency and vacuum wavelength for downward emission.
- 1.The photon receives the gap, not either absolute atomic energy: ΔE = 2.3 × 1.602 × 10⁻¹⁹ = 3.685 × 10⁻¹⁹ J.
- 2.ν = ΔE/h = 3.685 × 10⁻¹⁹ / (6.626 × 10⁻³⁴) = 5.56 × 10¹⁴ Hz.
- 3.λ = 1240/2.3 nm = 539 nm, approximately visible green. A larger energy gap would mean higher frequency and shorter wavelength.
Problem
Find the photon wavelength and frequency needed to excite hydrogen from n = 1 to n = 4.
- 1.E₁ = −13.6 eV and E₄ = −0.85 eV. Absorption needs ΔE = E₄ − E₁ = 12.75 eV.
- 2.λ = 1240/12.75 = 97.3 nm. Convert the gap to joules and divide by h to obtain ν ≈ 3.08 × 10¹⁵ Hz.
- 3.The photon is ultraviolet. The energy is below 13.6 eV, so this transition excites the atom without ionising it.
Families of lines and cascade paths
Hydrogen emissions ending at n = 1 form the Lyman family in the ultraviolet. Those ending at n = 2 form the Balmer family; its familiar first lines lie in the visible, while higher members approach the near-ultraviolet. Transitions ending at n = 3 form the infrared Paschen family. These names group final states, not the number of photons or the brightness of a line. Their qualitative pattern follows directly from the gaps.
An atom prepared in n = 3 can return directly to n = 1, or it can cascade through n = 2. In the direct route it emits one photon. In the two-step route it emits two photons, each with a smaller energy. Their energies add to the same initial-to-final difference. Their frequencies add as energy bookkeeping, but their wavelengths do not: wavelength is inversely related to energy.
Problem
An initially ground-state atomic hydrogen sample is excited by 12.5 eV electrons. Which line families and candidate wavelengths can result in the ideal principal-level picture?
- 1.The highest accessible principal level is n = 3. Lower excited levels may also be populated by collisions or cascades. The relevant gaps are 3 → 2, 3 → 1 and 2 → 1.
- 2.ΔE₃→₂ = 1.889 eV gives λ ≈ 656 nm. ΔE₃→₁ = 12.089 eV gives λ ≈ 102.6 nm. ΔE₂→₁ = 10.2 eV gives λ ≈ 121.6 nm.
- 3.These comprise a Balmer line and Lyman lines. A particular atom need not emit all three photons. Across an ensemble different excitation and decay paths can produce the lines; exact strengths depend on populated quantum states and transition probabilities.
A photon frequency is not an orbital clock
The Bohr revolution frequency at n = 1 is about 6.6 × 10¹⁵ Hz, but the stationary ground state does not radiate continuously. A 2 → 1 photon has frequency about 2.47 × 10¹⁵ Hz, determined by its two level energies. Confusing these two frequencies reinstates the classical model’s error. At very large n, adjacent-level photon frequencies approach the classical revolution frequency. That limiting agreement is useful, while finite low levels remain distinctly quantum.
For emissions 3 → 2 and 4 → 2, which has the shorter wavelength? The n = 4 initial state is higher, so 4 → 2 has the larger energy gap and the shorter wavelength, about 486 nm rather than 656 nm. Equal final states do not mean equal photon energies.
Quick Quiz
Quiz
A photon is emitted in which change?
Emission transfers positive energy away from the atom, so the final atomic energy is lower.
Which quantity determines a photon frequency?
The transition postulate is hν = |Ef − Ei|. Neither absolute level energy alone specifies the line.
Which hydrogen emission has the larger photon energy?
E₄ is higher than E₃ and both end at E₂, giving 4 → 2 the larger drop.
Why might cold ground-state hydrogen lack strong visible Balmer absorption?
Balmer absorption starts at n = 2; matching gaps exist but need atoms occupying the lower state.
For a cascade with two photons, which relation is valid?
Energy conservation adds the photon energies. Wavelengths do not add because each is inversely related to its photon energy.
Practice Problems
- An atom emits a photon when its energy changes from −5.0 eV to −7.4 eV. Calculate photon energy, frequency and vacuum wavelength.
- Calculate the hydrogen 4 → 2 photon wavelength and identify the line family.
- Compare direct 3 → 1 emission with a 3 → 2 → 1 cascade. Give the photon energies and show energy conservation.
- Find the shortest-wavelength limit for transitions ending at n = 2 using the level-energy limit.
- For atoms initially at principal level n = 4, how many distinct principal-level transition gaps are possible across an ensemble if lower levels become populated? Why is this not the photon count of one atom?
- Explain why a line spectrum can identify a gas but line brightness is not fixed by the energy-gap formula.
Ei − Ef = −5.0 − (−7.4) = 2.4 eV. Convert to 3.845 × 10⁻¹⁹ J. Divide by 6.626 × 10⁻³⁴ J s to obtain ν = 5.80 × 10¹⁴ Hz. λ = 1240/2.4 = 517 nm. The photon energy is positive although both atomic energies are negative.
Key Takeaways
• Atomic line positions come from differences between allowed energies. • Emission lowers atomic energy; absorption raises it. • Photon energy is hν = hc/λ and is positive. • Use compatible units when converting eV into frequency or wavelength. • Absorption lines require atoms in the corresponding lower states. • A cascade conserves the sum of photon energies, not the sum of wavelengths. • Line families group transitions by their final principal level. • Photon frequency generally differs from Bohr revolution frequency.
Finished this lesson? Mark it complete to track your progress.
Loading your progress…