Skip to lesson content

Lesson 4 of 7

Electromagnetic Waves · Lesson 4 of 7

Energy in Electromagnetic Waves

“Derive equal electric and magnetic energy densities and distinguish amplitude, average energy and photon energy.”

Learning Objectives

• Derive equality of electric and magnetic energy densities for a vacuum travelling wave. • Calculate peak and time-averaged energy densities. • Explain energy transfer from a source to an absorber. • Predict how changing field amplitude affects carried energy.

Radiation can deliver energy without delivering source charges

Sunlight warms a surface even though no wire connects it to the Sun. A receiving antenna acquires an electrical signal while its electrons remain in the receiver. The incoming fields act on local charges, and some field energy is transferred to matter. Reflection, transmission and absorption compete; a wave does not necessarily deposit all its energy on the first surface it meets.

Energy density u means energy per volume, in J/m³. It is distinct from power in watts and from intensity, which is average power per area in W/m². A field can store energy in an empty region. Recall the energy density of a capacitor’s electric field and of a magnetic field associated with an inductor. In vacuum these field-energy expressions provide the starting point; a detailed microscopic treatment inside absorbing matter needs more care.

Instantaneous field energy densities in vacuumLaTeX
E and B here are instantaneous magnitudes, not peak amplitudes or RMS values. Each contribution is nonnegative and has units J/m³.

Why the two contributions are equal

For a single travelling vacuum plane wave, E = cB at every event. Square this relation and substitute c² = 1/(μ₀ε₀). Starting from the magnetic energy makes the cancellation explicit. This is not an equality of E and B themselves; the constants convert their different units into comparable energy densities.

Equality derived from the wave relationLaTeX
Because μ₀c² = 1/ε₀, the magnetic term becomes exactly the electric term. The equality is specific to the single travelling plane-wave conditions.

This result is stronger than equality of averages: the contributions are equal instantaneously in this model. They peak together and vanish together. The wave does not alternate between an all-electric stage and an all-magnetic stage like energy exchanging between an ideal capacitor and inductor in a lumped LC oscillator. A standing electromagnetic wave formed by superposition has a different local pattern; do not extend the pointwise equality to every possible field configuration.

A sinusoid and its square have different averages

At one fixed location let E = E₀ sin θ, where θ advances uniformly in time. Then E² = E₀² sin² θ. The field changes sign, but energy density does not. Over a full cycle the mean of sin θ is zero while the mean of sin² θ is one half. One way to see the second result is that sine-squared and cosine-squared have the same full-cycle average and add to one; each must average to one half.

Time averages over complete cyclesLaTeX
The total peak density is ε₀E₀². Angle brackets denote a time average. E_rms = E₀/√2, so the same total average is ε₀E_rms².
Energy densities during one cycleut / TTotal uu_E = u_B (overlap)01/21Both contributions rise and fall together; neither is negative.
The fields do not take turns storing wave energy— One location in a sinusoidal travelling vacuum wave; electric and magnetic curves lie on top of each other. Vertical scale is qualitative.

Predict the effect of doubling amplitude while keeping frequency fixed. Both E₀ and B₀ double because their ratio remains c. Their squared energy densities therefore become four times as large. The wavelength, frequency and vacuum speed stay unchanged. A zero average signed electric field does not imply zero energy transport, because the average of a square is not the square of the average.

Recalculate the average densities

Problem
A sinusoidal vacuum wave has E₀ = 48 V/m and f = 2.0 × 10¹⁰ Hz. Find λ, B₀ and both average energy contributions.

  1. 1.λ = c/f = 0.015 m. B₀ = E₀/c = 1.60 × 10⁻⁷ T.
  2. 2.Using ε₀ = 8.85 × 10⁻¹² F/m, each average is ε₀E₀²/4 = (8.85 × 10⁻¹²)(2304)/4 = 5.10 × 10⁻⁹ J/m³.
  3. 3.The total mean is 1.02 × 10⁻⁸ J/m³. Independently substituting B₀ into B₀²/(4μ₀) gives the same magnetic contribution within the rounded constants.

From energy density to energy crossing an area

As a useful extension, imagine a uniform plane wave crossing area A perpendicular to travel. During a small interval Δt it advances a distance cΔt, so the corresponding volume is AcΔt. Multiplying average density by that volume gives transferred energy. Dividing by AΔt gives the average intensity. This reasoning concerns a travelling wave and a perpendicular surface; oblique surfaces require the projected area.

Intensity: a limited extension of the energy argumentLaTeX
I here denotes intensity, not the capacitor current used earlier. U = IAΔt assumes uniform, steady average intensity and a perpendicular area. Absorbed energy can be less than incident energy.

The units provide a check: (J/m³)(m/s) = W/m². The direction of energy transport is E crossed with B. A full vector energy-flow theory is unnecessary for the present calculations. Frequency controls photon energy through hf, introduced later; field amplitude controls classical intensity at fixed frequency. These statements describe different aspects of the same radiation and should not be collapsed into “higher frequency always means greater total power.”

Energy delivered to an ideal absorber

Problem
A uniform wave of intensity 12 W/m² falls normally on an ideal absorbing area 0.020 m² for 5.0 s. Find absorbed energy.

  1. 1.Power intercepted is IA = 12 × 0.020 = 0.24 W. Energy = power × time = 1.2 J.
  2. 2.If only half the incident radiation were absorbed, absorbed energy would be 0.60 J. Reflection and transmission matter; the incident intensity alone does not specify absorbed heat.

What field forces do and do not imply

The magnetic part of the Lorentz force is perpendicular to an individual charge’s velocity, so it does no direct mechanical work on that charge. This does not prevent an electromagnetic wave from transferring energy: its electric field can do work, and the magnetic field is part of the coupled travelling configuration. Charges and molecules may then redistribute the energy through collisions, electronic changes or molecular motion. The microscopic absorption process depends on both the radiation frequency and the material.

The source loses energy as the radiation leaves. At an absorber field energy can become internal energy or electrical energy. A freely propagating pulse need not be continually fed by charges along its path. This distinction explains how radiation crosses vacuum while an electric current in an ordinary wire needs charge carriers in the wire.

Quick Quiz

Quiz

Quick check

For one travelling vacuum plane wave, u_E and u_B are

Explanation: Substituting E = cB and c² = 1/(μ₀ε₀) gives equality at every event.

Quick check

If E₀ doubles at fixed frequency, total average energy density becomes

Explanation: Energy density is proportional to the square of amplitude.

Quick check

Why can a sinusoidal E average to zero while its energy density does not?

Explanation: The mean of E² is positive, although positive and negative E average to zero.

Quick check

Total mean energy density for a sinusoidal vacuum plane wave is

Explanation: Each field contributes ε₀E₀²/4 on average.

Quick check

Which statement about wave energy transfer is correct?

Explanation: The electric part of the Lorentz force can transfer energy to matter.

Practice Problems

Practice Problems
  1. Derive equality of average field energy densities using amplitudes rather than instantaneous values.
  2. For E₀ = 100 V/m, calculate peak total density and average total density.
  3. A sinusoidal wave has total mean density 2.0 × 10⁻⁸ J/m³. Find intensity and energy incident normally on 10 cm² in 2 s.
  4. One wave has twice another’s frequency but the same E₀. Compare their classical vacuum speeds and average intensities.
  5. Correct the claim: “The wave stores electric energy at one instant and changes it all into magnetic energy a quarter-cycle later.”

For a sinusoid, average electric density is ε₀E₀²/4 and average magnetic density is B₀²/(4μ₀). Substitute B₀ = E₀/c into the second: it becomes E₀²/(4μ₀c²) = ε₀E₀²/4. Both therefore contribute half of total average energy. This uses the travelling vacuum-wave relation.

Key Takeaways

Key Takeaways

• Electromagnetic radiation carries energy from its source. • Vacuum electric and magnetic energy densities are ε₀E²/2 and B²/(2μ₀). • The two contributions are equal in a single travelling vacuum plane wave. • Their total mean is ε₀E₀²/2 for sinusoidal fields. • Doubling field amplitude quadruples average energy density. • A zero signed mean field can have positive mean energy density. • Absorption depends on the receiving material as well as radiation properties.

Finished this lesson? Mark it complete to track your progress.

Loading your progress…