Electricity: Circuits and their Components · NCERT Solved Problems
Exercise LEUL
Let Us Enhance Our Learning
11 problems
- Choose the incorrect statement. (i) A switch is the source of electric current in a circuit. (ii) A switch helps to complete or break the circuit. (iii) A switch helps us to use electricity as per our requirement. (iv) When the switch is in 'OFF' position, there is an air gap between its terminals.
- Observe Fig. 3.16. With which material connected between the ends A and B, the lamp will not glow?
- In Fig. 3.17, if the filament of one of the lamps is broken, will the other glow? Justify your answer.
- A student forgot to remove the insulator covering from the connecting wires while making a circuit. If the lamp and the cell are working properly, will the lamp glow?
- Draw a circuit diagram for a simple torch using symbols for electric components.
- In Fig. 3.18: (i) If S2 is in 'ON' position, S1 is in 'OFF' position, which lamp(s) will glow? (ii) If S2 is in 'OFF' position, S1 is in 'ON' position, which lamp(s) will glow? (iii) If S1 and S2 both are in 'ON' position, which lamp(s) will glow? (iv) If both S1 and S2 are in 'OFF' position, which lamp(s) will glow?
- Vidyut has made the circuit as shown in Fig. 3.19. Even after closing the circuit, the lamp does not glow. What can be the possible reasons? List as many possible reasons as you can for this faulty operation. What will you do to find out why the lamp did not glow?
- In Fig. 3.20, in which case(s) the lamp/LED will not glow when the switch is closed? (a) (b) (c) (d)
- Suppose the '+' and '−' symbols cannot be read on a battery. Suggest a method to identify the two terminals of this battery.
- You are given six cells marked A, B, C, D, E, and F. Some of these are working and some are not. Design an activity to identify which of them are working. (i) List the items that you require. (ii) Write the procedure that you will follow. (iii) With the items, carry out the activity to identify the cells that are working.
- Using an LED that requires two cells in series to glow, Tanya made the circuit as shown in Fig. 3.21. Will the lamp glow? If not, draw the wires for correct connections.