Electricity · NCERT Solved Problems
Exercise 1
Exercises
18 problems
- A piece of wire of resistance R is cut into five equal parts. These parts are then connected in parallel. If the equivalent resistance of this combination is R′, then the ratio R/R′ is – (a) 1/25 (b) 1/5 (c) 5 (d) 25
- Which of the following terms does not represent electrical power in a circuit? (a) I²R (b) IR² (c) VI (d) V²/R
- An electric bulb is rated 220 V and 100 W. When it is operated on 110 V, the power consumed will be – (a) 100 W (b) 75 W (c) 50 W (d) 25 W
- Two conducting wires of the same material and of equal lengths and equal diameters are first connected in series and then parallel in a circuit across the same potential difference. The ratio of heat produced in series and parallel combinations would be – (a) 1:2 (b) 2:1 (c) 1:4 (d) 4:1
- How is a voltmeter connected in the circuit to measure the potential difference between two points?
- A copper wire has diameter 0.5 mm and resistivity of 1.6 × 10⁻⁸ Ω m. What will be the length of this wire to make its resistance 10 Ω? How much does the resistance change if the diameter is doubled?
- The values of current I flowing in a given resistor for the corresponding values of potential difference V across the resistor are given below – I (amperes) 0.5 1.0 2.0 3.0 4.0 V (volts) 1.6 3.4 6.7 10.2 13.2 Plot a graph between V and I and calculate the resistance of that resistor.
- When a 12 V battery is connected across an unknown resistor, there is a current of 2.5 mA in the circuit. Find the value of the resistance of the resistor.
- A battery of 9 V is connected in series with resistors of 0.2 Ω, 0.3 Ω, 0.4 Ω , 0.5 Ω and 12 Ω, respectively. How much current would flow through the 12 Ω resistor?
- How many 176 Ω resistors (in parallel) are required to carry 5 A on a 220 V line?
- Show how you would connect three resistors, each of resistance 6 Ω, so that the combination has a resistance of
- (i)9 Ω
- (ii)4 Ω
- Several electric bulbs designed to be used on a 220 V electric supply line, are rated 10 W. How many lamps can be connected in parallel with each other across the two wires of 220 V line if the maximum allowable current is 5 A?
- A hot plate of an electric oven connected to a 220 V line has two resistance coils A and B, each of 24 Ω resistance, which may be used separately, in series, or in parallel. What are the currents in the three cases?
- Compare the power used in the 2 Ω resistor in each of the following circuits:
- (i)a 6 V battery in series with 1 Ω and 2 Ω resistors
- (ii)a 4 V battery in parallel with 12 Ω and 2 Ω resistors
- Two lamps, one rated 100 W at 220 V, and the other 60 W at 220 V, are connected in parallel to electric mains supply. What current is drawn from the line if the supply voltage is 220 V?
- Which uses more energy, a 250 W TV set in 1 hr, or a 1200 W toaster in 10 minutes?
- An electric heater of resistance 44 Ω draws 5 A from the service mains for 2 hours. Calculate the rate at which heat is developed in the heater.
- Explain the following.
- (a)Why is the tungsten used almost exclusively for filament of electric lamps?
- (b)Why are the conductors of electric heating devices, such as bread-toasters and electric irons, made of an alloy rather than a pure metal?
- (c)Why is the series arrangement not used for domestic circuits?
- (d)How does the resistance of a wire vary with its area of cross-section?
- (e)Why are copper and aluminium wires usually employed for electricity transmission?